Republic of the Congo · elevation 1870 ft AMSL
· -2.8467, 13.8212
Zanaga Airport is an airport with the ICAO code FCBZ and the IATA code ANJ. Country: Republic of the Congo. Nearest settlement listed in the database: Zanaga. OurAirports classifies it as a small airport. Its ICAO code starts with the FC prefix, which marks airports in Republic of the Congo. The four-letter code FCBZ is used in flight operations and weather reports, while the three-letter IATA code ANJ is used for ticketing and baggage handling. The airport reference point sits at 2°50'48"S, 13°49'16"E, at an elevation of 1,870 ft (570 m) above sea level. The applicable time zone is Africa/Brazzaville.
Aerial imagery showing the runway and apron layout - the zoom is matched to the longest runway.
| Threshold | Course | Length | Width | Surface |
|---|---|---|---|---|
| 08 | 80° | 1,205 m (3,953 ft) | no data | unpaved |
| 26 | 260° |
The course is derived from the runway designator (number × 10), not from a survey - the actual magnetic bearing can differ by a few degrees.
Declared distances (TORA, TODA, ASDA, LDA) are published in the national AIP - they are not part of this table.
According to the infobox on the English Wikipedia, Zanaga Airport has one runway: 08/26 - 1,205 m long (3,953 ft), unpaved surface.
No OurAirports data is available for this airport, so the figures above come from Wikipedia - a community-edited source that can be out of date. The infobox also gives no runway width. Treat these numbers as indicative and check the current AIP before flying.
The thresholds are oriented as follows: 08/26 on 80° and 260° magnetic. A threshold designator is its magnetic heading divided by ten (ICAO Annex 14), so the runway axis can be read straight off the numbers.
For the 08/26 axis, wind from the south (around 170°) or from the north (around 350°) blows perpendicular to the runway and produces the largest crosswind component. Wind from around 80° or 260° acts along the runway, as a headwind or a tailwind. The decoder on this page computes those components automatically from the current METAR.
Weather reports for Zanaga Airport are published under the ICAO code FCBZ. A METAR is an observation of current conditions, usually issued every 30 or 60 minutes; a TAF is a forecast for the airport area, typically covering 9 to 30 hours.
The decoder breaks the FCBZ report down into its parts: wind direction and speed including gusts and variability, visibility (including CAVOK and directional minimum visibility), weather phenomena by WMO code, cloud layers with their bases, temperature and dew point, QNH pressure, and the resulting flight category - VFR, MVFR, IFR or LIFR - using FAA thresholds.
Not every airport issues its own reports; many smaller airfields have no weather station. If no current data is available for FCBZ, check the nearby airports listed below.
Reports always use UTC (the Z suffix). The Africa/Brazzaville zone stays at GMT+01:00 year-round, so converting to local time is always the same shift.
The closest airports in the database, measured in a straight line from the reference point, are Lague Airport (FCBL, 91 km), Sibiti Airport (FCBS, 106 km), Sidetra Airport (FCMD, 106 km). When no report is available for FCBZ, they usually give the best approximation of conditions in the area.
METAR Academy
Step-by-step guides - with examples, charts and calculators.
Advertisement
Pass your ICAO Aviation English exam - 100% online
ICAO Level 4, 5 or 6 for PPL(A)/CPL(A)/ATPL(A): aviation vocabulary, radio phraseology, pronunciation and standard/emergency flight scenarios. Buy through this link and get a 10% discount.
Advertisement
VFR Map Europe - your aeronautical chart in the cockpit
Moving GPS map, airspace and zones, airspace alerts and offline use. Plan your VFR route online for free and send it to the app. The online map is free.
Check VFR MapRun a flying club, a training organisation or an airfield website? Embed a ready-made panel with the current FCBZ METAR - flight category, wind, visibility, temperature and pressure, refreshed automatically. The configurator lets you pick language, theme and units; you paste the code once.
