Runways at OMDL
According to OurAirports data (compiled from AIP and FAA sources), Delma Airport (Delma Island) has one runway: 17/35 - 2,500 m long (8,202 ft), 47 m wide, asphalt surface.
United Arab Emirates · elevation 30 ft AMSL
· 24.5100, 52.3352
Delma Airport (Delma Island) is an airport with the ICAO code OMDL and the IATA code ZDY. Country: United Arab Emirates. Nearest settlement listed in the database: Delma Island. OurAirports classifies it as a small airport. Its ICAO code starts with the OM prefix, which marks airports in United Arab Emirates. The four-letter code OMDL is used in flight operations and weather reports, while the three-letter IATA code ZDY is used for ticketing and baggage handling. The airport reference point sits at 24°30'36"N, 52°20'07"E, at an elevation of 30 ft (9 m) above sea level. The applicable time zone is Asia/Dubai.
Aerial imagery showing the runway and apron layout - the zoom is matched to the longest runway.
| Threshold | Course | Length | Width | Surface |
|---|---|---|---|---|
| 17 | 170° | 2,500 m (8,202 ft) | 47 m (154 ft) | asphalt |
| 35 | 350° |
The course is derived from the runway designator (number × 10), not from a survey - the actual magnetic bearing can differ by a few degrees.
Declared distances (TORA, TODA, ASDA, LDA) are published in the national AIP - they are not part of this table.
According to OurAirports data (compiled from AIP and FAA sources), Delma Airport (Delma Island) has one runway: 17/35 - 2,500 m long (8,202 ft), 47 m wide, asphalt surface.
The thresholds are oriented as follows: 17/35 on 170° and 350° magnetic. A threshold designator is its magnetic heading divided by ten (ICAO Annex 14), so the runway axis can be read straight off the numbers.
For the 17/35 axis, wind from the west (around 260°) or from the east (around 80°) blows perpendicular to the runway and produces the largest crosswind component. Wind from around 170° or 350° acts along the runway, as a headwind or a tailwind. The decoder on this page computes those components automatically from the current METAR.
Weather reports for Delma Airport (Delma Island) are published under the ICAO code OMDL. A METAR is an observation of current conditions, usually issued every 30 or 60 minutes; a TAF is a forecast for the airport area, typically covering 9 to 30 hours.
The decoder breaks the OMDL report down into its parts: wind direction and speed including gusts and variability, visibility (including CAVOK and directional minimum visibility), weather phenomena by WMO code, cloud layers with their bases, temperature and dew point, QNH pressure, and the resulting flight category - VFR, MVFR, IFR or LIFR - using FAA thresholds.
Not every airport issues its own reports; many smaller airfields have no weather station. If no current data is available for OMDL, check the nearby airports listed below.
Reports always use UTC (the Z suffix). The Asia/Dubai zone stays at GMT+04:00 year-round, so converting to local time is always the same shift.
The closest airports in the database, measured in a straight line from the reference point, are Sir Bani Yas Airport (OMBY, 35 km), Arzanah Airport (Arzanah Island) (OMAR, 38 km), Jebel Dhanna Airport (OMAJ, 46 km). When no report is available for OMDL, they usually give the best approximation of conditions in the area.
METAR Academy
Step-by-step guides - with examples, charts and calculators.
Advertisement
Pass your ICAO Aviation English exam - 100% online
ICAO Level 4, 5 or 6 for PPL(A)/CPL(A)/ATPL(A): aviation vocabulary, radio phraseology, pronunciation and standard/emergency flight scenarios. Buy through this link and get a 10% discount.
Advertisement

VFR Map Europe - your aeronautical chart in the cockpit
Moving GPS map, airspace and zones, airspace alerts and offline use. Plan your VFR route online for free and send it to the app. The online map is free.
Check VFR MapRun a flying club, a training organisation or an airfield website? Embed a ready-made panel with the current OMDL METAR - flight category, wind, visibility, temperature and pressure, refreshed automatically. The configurator lets you pick language, theme and units; you paste the code once.